3.2 Folding

When a body of rock, especially sedimentary rock, is squeezed from the sides by tectonic forces, it is likely to fracture and/or become faulted if it is cold and brittle, or become folded if it is warm enough to behave in a plastic manner.

The nomenclature and geometry of folds are summarized on Figure 3.5.  An upward fold is called an anticline, while a downward fold is called a syncline. In many areas it’s common to find a series of anticlines and synclines (as in Figure 3.5), although some sequences of rocks are folded into a single anticline or syncline. A plane drawn through the crest of a fold in a series of beds is called the axial plane of the fold. The sloping beds on either side of an axial plane are limbs. An anticline or syncline is described as symmetrical if the angles between each of limb and the axial plane are generally similar, and asymmetrical if they are not. If the axial plane is sufficiently tilted that the beds on one side have been tilted past vertical, the fold is known as an overturned anticline or syncline.

Figure 12.5 Examples of different types of folds and fold nomenclature.  Axial planes are only shown for the anticlines, but synclines also have axial planes. [SE]
Figure 3.5 Examples of different types of folds and fold nomenclature. Axial planes are only shown for the anticlines, but synclines also have axial planes. [SE]

A very tight fold, in which the limbs are parallel or nearly parallel to one another is called an isoclinal fold (Figure 3.6). Isoclinal folds that have been overturned to the extent that their limbs are nearly horizontal are called recumbent folds.

Figure 12.6 An isoclinal recumbent fold [SE]
Figure 3.6 An isoclinal recumbent fold [SE]

Folds can be of any size, and it’s very common to have smaller folds within larger folds (Figure 3.7).  Large folds can have wavelengths of tens of kilometres, and very small ones might be visible only under a microscope. Anticlines are not necessarily, or even typically, expressed as ridges in the terrain, nor synclines as valleys. Folded rocks get eroded just like all other rocks and the topography that results is typically controlled mostly by the resistance of different layers to erosion (Figure 3.8).

Figure 12.7 Folded limestone (grey) and chert (rust-coloured) in Triassic Quatsino Fm. rocks on Quadra Island, BC.  The image is about 1 m across. [SE]
Figure 3.7 Folded limestone (grey) and chert (rust-coloured) in Triassic Quatsino Formation rocks on Quadra Island, B.C.  The image is about 1 m across. [SE]

 

Figure 12.8 Example of the topography in an area of folded rocks that has been eroded.  In this case the blue and grey rocks are most resistant to erosion, and are represented by hills. [SE]
Figure 3.8 Example of the topography in an area of folded rocks that has been eroded. In this case the green and grey rocks are most resistant to erosion, and are represented by hills. [SE]

Exercises

Exercise 3.1  Folding Style

This photograph shows folding in the same area of the Rocky Mountains as Figure 3.1.  Describe the types of folds using the appropriate terms from above (symmetrical, asymmetrical, isoclinal, overturned, recumbent etc.).  You might find it useful to first sketch in the axial planes.

Folding style

 

License

Icon for the Creative Commons Attribution 4.0 International License

Physical Geology Copyright © 2015 by Steven Earle is licensed under a Creative Commons Attribution 4.0 International License, except where otherwise noted.

Share This Book